Using the cable cover

Putting the power cord and remote control unit away
Installing the cable cover

#

Remote control unit

 

(Infrared emitter)

Hook1Hook2

$

#Put the remote control unit into the cable cover with the buttons facing downward to prevent them from being pressed.

$Put the power cord and other cables into the cable cover.

%

Velcro

'˛

˛'

˛(

&˛

%Put the Velcro through the hole, and tape it to prevent the cables from dropping out.

&Insert the hook 1 of the cable cover into the mounting holes in the projector.

'Push in the hook 2 until it locks into place.

(Tighten the screw by turning it clockwise.
Removing the cable cover

 

$˛

#Loosen the screw by turning it

 

 

anticlockwise.

 

$˛

$Release the two hooks at the

 

 

top of the cable cover.

 

%

%Pull the cable cover to the

 

#

rear to remove it from the

 

 

projector.

NOTE

:

 

Do not lift up the projector by holding the cable cover, otherwise the cable cover might come off.

62-ENGLISH