Panasonic PT-L785U Using the REMOTE connector, Others, Pin assignments and signal names, DVI, Open, Lamp, Open, Open, Open, Open, RGB2, RGB3, Short, Short, Short, Ground

Using the REMOTE connectorUsing the REMOTE connector which is on the connector panel of the

projector, it is possible to operate the projector from an external location from where infrared remote control signals cannot be received, by using a remote control panel.

Pin assignments and signal names

6	9			Pin No.			Signal Name		Contents
					#		GND	Ground
					$		POWER	Power ON
1	5				%		INPUT SEL3	Input signal select3
					&			NC
D-sub 9-pin
					'		INPUT SEL1	Input signal select1
Appearance
					(		INPUT SEL2	Input signal select2
					)			NC
					*			NC
					+		ENABLE	Enables remote terminal control
Short pin		# and pin			+ when controlling.
Power ON/OFF
Pin No.						Setting
$-#			Short				Open
Lamp			ON				OFF (standby)

Switching the input mode

Pin No.				Setting
%-#	Open	Open	Short	Short	Short	Open
'-#	Open	Short	Open	Open	Short	Open
(-#	Open	Open	Short	Open	Open	Short
Input Signal	RGB1	RGB2	RGB3	VIDEO	S-VIDEO	DVI

NOTE :

BThe POWER, RGB and VIDEO buttons on the remote control unit and

projector will not operate when pins		# and	+ are shorted. RS-232C
commands will also be ignored.
BDo not short pins	#, $, %, ', or	( when pin	+ is open. If this is

done, the projector will ignore signals from the remote control unit.

Others

E NGLISH -71