Covering the connector panel

When installing the projector to the ceiling, the accessory cable cover can be used to cover the connectors after removing the cut-away parts.

#Use pliers or similar to break the perforated sections of the cutaway parts.

Perforated sections

$Work the cut-away parts back and forth several times to break the fixing tabs. Smooth off any jagged edges if necessary.

Hook2

Hook1

Fixing tabs Fixing tabs

%Pass the mains lead through cutaway part S, pass the other cables through cut-away part L, and then insert the hook1 of the cable cover into the mounting holes in the projector.

&Push in the hook 2 until it locks into place.

Cut-away part S

Cut-away part L

'Tighten the screw by turning it clockwise.Screw

Refer to page 62 for details on removing the cable cover.

NOTE:

BDo not cover the air inlet ports when using the cable cover as stated above.

BDo not place any heavy objects on the cable cover to prevent it from falling.

BDo not bend the cables greatly, otherwise it will be difficult to attach the cable cover.

BRemove the cable cover when cleaning or replacing the air filter.

Others

E NGLISH

-63