S1 video signals

BS1 video signals are a type of video signal with an aspect ratio of 16:9 which include a detector signal. This detector signal is output by some sources such as wide-vision video decks.

BWhen “ASPECT” is set to “AUTO”, the projector recognizes the

detector signal and automatically switches the aspect ratio to 16:9.

NOTE:

BIf a selected mode does not match the aspect ratio of the input signal, it may affect the quality of viewing of the original picture. Keep this in mind when selecting the aspect ratio.

BIf using this projector in places such as cafes or hotels to display programs for a commercial purpose or for public presentation, note that if the aspect ratio (16:9) selection function is used to change the aspect ratio of the screen picture, you may be infringing the rights of the original copyright owner for that program under copyright protection laws.

BIf a normal (4:3) picture which was not originally intended for wide-screen viewing is projected onto a wide screen, distortion may occur around

the edges of the picture, or part of the picture may not be visible. Such programs should be viewed in 4:3 mode to give proper consideration to the aims and intentions of the original programme’s creator.

RESIZING

This should normally be set to “ON”. (This setting is only for signals which have lower resolutions than

the LCD panels. Refer to page 70 for details.)

ON

The pixel resolution of the input signal is converted to the same resolution as the LCD panels before being projected. For signals with lower resolutions, gaps in the pixels are automatically interpolated into the picture before it is projected. This may sometimes cause

problems with the quality of the picture.

OFF

The input signal is projected at its original resolution, with no pixel conversion. The projected picture will be smaller than normal, so adjust the zoom setting or move the projector forwards or backwards to adjust the picture size if necessary.

If set to “OFF”, some features, such as “D.ZOOM” (digital zoom) or “KEYSTONE” will not function.

AUTO SETUP

This item functions in the same way as the AUTO SETUP button on the remote control unit and the projector control panel. (page 28)

FRAME LOCK

If the picture’s condition is bad while a RGB moving picture is projected,

set “FRAME LOCK” to “ON”. Refer to page 70 for compatible RGB

signals.

Adjustments and settings

E NGLISH

-45