Remote Control Transmitter | Panasonic TC-29G12P instruction

- 16 -

Remote Control Transmitter

Inserting batteries

1.Open the cover of the battery compartment, located on the back of the remote control unit.

2.Insert the batteries in the compartment, paying attention to correct polarities, as shown in the illustration.

3.Close the battery compartment, sliding the cover in place.

Useful Suggestions:

Replace batteries when noticing any failure in the functioning of the remote control unit.

If the remote control is frequently used, we recommend the use of alkaline batteries, with longer life.damage the unit.

Precautions when using batteries

The incorrect insertion of batteries in the compartment can cause leaking and corrosion of metal parts, and may Observe the following precautions:

1.Batteries should be replaced in pairs.

2.Do not mix new and used batteries.

3.Do not mix different types of batteries (for example, carbon-zinc with alkaline batteries).

4.Do not attempt to charge, short-circuit, open, warm up or burn used batteries.

5.Remove the batteries from the unit, if the unit is not going to be used for a long while.

COVER

PUSH AND

PULL TO

OPEN THE

COVER OF

THE BATTERY

COMPARTMENT

POLARITY

Operation Guide

TC-20G12P / TC-29G12P

Note:

Once discharged, the batteries included with this product may be disposed off with domestic trash.

/ TC-29G12PU

Image 16

Panasonic TC-29G12P service manual Remote Control Transmitter, Inserting batteries

Contents

Remote Control Transmiter Provided accessoriesTelevisor TC-20G12P TC-29G12P TC-29G12PU Important Safety Notice Table of Contents Remote control Operation GuideFrontal View Rear view How to connect an external antenna TC-20G12P / TC-29G12P Operation Selection of audio mode STEREO, SAP, Mono and Sound AI Selecting the Menu language Operation Operation Guide Game Guard Programming timer ON/OFF Automatic turning off Sleep Timer Setting Characteristic Operation Antenna mode Automatic channel tuning Manual channel tuning Auto Power on Subtitles display mode cc Mode Channel caption Connecting to an amplifier stereo equipment Connecting to a videocassette recorder VCROperation Guide Remote Control Transmitter Inserting batteries Service Adjustments and Calibrations PowerInitial Data Recording in the Memory Eeprom Data Memory on the Screen Deflection Circuit PRE-ADJUSTEMENTS AGC Circuit PRE-ADJUSTMENTSWhite Balance Adjustments Electrical Inspections AFT Adjustments RF AGC Adjustment If Detector Output AdjustmentSUB-CONTRAST Adjustment +B Voltage Verification Ntsc SUB-TINT Adjustment PAL SUB-COLOR AdjustmentSUB-BRIGH PRE-ADJUSTMENT MTS Circuit Adjustment Audio Outpup Level Verification Synthetizer Adjustments Deflection Circuit AdjustmentHUM Verification Audio Output Check UP CRT CUT OFF Adjustment White Balance Adjustment SUB Bright Adjustment Focus AdjustmentColor Killer Verification Filament Voltage Check UP Dynamic Convergence Adjustment Purity and Convergence AdjustmentsVerify Purity Adjustment with the Help of a Microscope Standard DAC table TC-20G12P / TC-29G12P / TC-29G12PU Waveforms IC001 Pins and Functions Sync IC601 Block Diagram IC601 Pins and Functions Board Components side Top view Board Foil side Bottom view Cabinet Parts Location Cabinet Replacement Parts List TC-20G12P TC-29G12P TC-29G12PU Replacement Parts List Capacitors Diodes Transistors ERDS2TJ181T Transformers Especial Replacement Parts Table Page CS Group Technical Support