Installation
How to connect an external antenna
To obtain the best audio and video quality it is necessary to install an external antenna, with adequate cables (75 ohms
Your local TV service can help you to acquire the adequate system and accessories for the installation of an external antenna in your location.
Any other options of installation, upgrading of existing systems or required accessories, and the cost for such options, are the owner’s responsibility.
- 4 -
Operation
POWER button
When pressed the TV set is placed on STAND BY, and it is necessary to press the button STAND BY on the set panel or POWER on the remote control to turn the TV set on.
STAND BY button
Use this button to turn the TV set on and off. The POWER button TV set must be in the ON position.
VOLUME buttons
Press these buttons to adjust sound level.
MUTE button
Press this button to temporarily turn off the sound.
On the screen the red icon “ª” will appear. To turn the sound back on press this button again.
Switching channels - two alternatives
1st alternative
Press the buttons CHANNEL ($or 4) to step back or forward through the channels, in the sequence in which they have been programmed.
2nd alternative
Enter the digits for the channel in the numerical keypad (for example, for channel 5 press the 0 button followed by the 5 button). For channels over 99, press sequentially the three buttons corresponding to the desired channel.
Operation Guide
TC-20G12P / TC-29G12P
Notes:
•When the TV set is turned on for the first time or when the channel is changed, useful information will be temporarily displayed on the screen.
•When using the numerical keypad in CABLE mode to select channels 10, 11, or 12, there is a delay before the channels are changed, due to the
possibility of the channels 100 to 125 being selected.
•If the signals for channels over 13 are not received, verify the type of antenna input (Cable or TV) and adjust the corresponding tune in (check item “Configuration properties” in the manual for the antenna type).
/
