Screensaver
Start
Function
Mode
Finish Time
Start Time
Scrolling bar only
Time Designation
6:15
12:30
Time 15:00
Screensaver
Start
Function
Mode
Operating Time
Periodic Time
Scrolling bar only
Interval
12:00
3:00
Time 15:00
Screensaver
Start
Function
Mode
Screensaver duration
Scrolling bar only
Standby after SCR Saver
6:15
Time 15:00
38
After selecting Time Designation, Interval or Standby after SCR Saver, the relevant Time Setup will become available
for selection and the Operating Time may be set. (Time cannot be set when “Mode” is “On” or “Off”.)
Press to select Start Time / Finish Time
(when Time Designation is selected).
Press to select Periodic Time / Operating Time
(when Interval is selected).
Press to select Screensaver duration
(when Standby after SCR Saver is selected).
Press to setup.
button: Forward
button: Back
Note: Timer function will not work unless “Time” is set.
Notes:
• Pressing “ ” or “ ” button once changes the Time 1 minute.
[However, switching occurs every 15 minutes when Periodic Time is selected.]
• Pressing “ �� or “ ” button continuously changes the Time by 15 minutes.
• “Screensaver duration” of the “Standby after SCR Saver” can be set from 0:00
to 23:59. When this is set to “0:00”, “ Standby after SCR Saver” will not be
activated.