Patton electronic 4900 user manual Connecting the Ethernet ports, RJ-45 Jack Signal Name

SmartNode 4900 User Manual 3 • Hardware installation

3.Select and attach the appropriate twisted-pair from each FXS device on punch-down blocks for connection to the chosen port on the IpChannel Bank.

Connecting the Ethernet ports

The IpChannel Bank has dual 10/100 Ethernet interfaces. One is for the WAN connection. The other is for connecting to your Ethernet LAN. The Ethernet ports will auto-sense the correct speed of the local LAN and automatically negotiate to half- or full-duplex operation. This section describes connecting the IpChannel Bank to the Ethernet LAN via an Ethernet hub or switch.

Connecting the 10/100Base-T Ethernet ports to an Ethernet switch or hub. The 10/100Base-T Ethernet port is designed to connect to an Ethernet switch or hub with a straight-through or cross-over Ethernet cable. The Ethernet RJ-45 pin and signal definitions for the SN4900 or for a NIC card in a workstation/PC are shown in figure 7. Connect a CAT-5 cable (one wired as shown in figure 8 or figure 9) between the SN4900 and the hub/switch.

RJ-45 Jack			Signal Name	Direction
	1	1	(TX+) Transmit Data +	Output
		2	(TX-) Transmit Data -	Output

23 (RX+) Receive Data + Input

3 4

	4	5
	5
	6	6 (RX-) Receive Data -			Input
	7	7
	8	8
Figure 7. Model SN4900 Ethernet port
SN4900			Hub
RJ-45 Pin No.			RJ-45 Pin No.
1 (TX+)			1 (RX+)
2 ( T X - )			2 ( R X - )
3 (RX+)			3 (TX+)
6 ( R X - )			6 ( T X - )
Figure 8. Straight-through RJ-45-to-RJ-45 Ethernet cable diagram
SN4900 10/100Base-T Port				PC 10/100Base-T Port
RJ-45 Pin No.				RJ-45 Pin No.
1 (TX+)			3		(RX+)
2 ( T X - )				6 ( R X - )
3 (RX+)				1	(TX+)
6 ( R X - )				2 ( T X - )

Figure 9. Cross-over RJ-45-to-RJ-45 Ethernet cable diagram

Installing the IpChannel Bank 30