SmartNode 4900 User Manual | 4 • Getting started with the SmartNode 4900 Series |
|
|
Introduction
This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration. Setting up a new SmartNode consists of the following main steps:
Note If you have not already installed the SmartNode, refer to chapter 3, “Hardware installation” on page 24.
1.Configuring the desired IP address (see figure 14). Refer to section “2. Connecting the SmartNode to the network” on page 41 for details.
| 240V |
| - Hz) |
(501 | AMP |
| 240V |
| - Hz) |
(501 | AMP |
00:A0:BA:00:04:10NIC ADDRESS
Activity |
| Console |
| Reset | Console port |
Status | Expansion |
0/0
ETH
0/1
ETH
Model
adapter and cable
Laptop PC
2.Connecting the SmartNode to the network (see figure 15). Refer to section “1. Configure IP address” on page 38 for details).
LAN
| 240V |
| - Hz) |
(501 | AMP |
| 240V |
| - Hz) |
(501 | AMP |
00:A0:BA:00:04:10NIC ADDRESS
Activity | Console |
| Reset |
Status | Expansion |
0/0 |
|
ETH |
|
0/1 |
|
ETH |
|
WAN |
|
(ETH 0/0)
PC or workstation | Network | |
interface | ||
or Telnet | ||
|
LAN (ETH 0/1)
Internet or
WAN (optional)
Introduction | 37 |