Patton electronic 4900 user manual Configure IP address, Factory-default IP settings

SmartNode 4900 User Manual 4 • Getting started with the SmartNode 4900 Series

3.Loading the configuration (see figure 16). Refer to section “2. Connecting the SmartNode to the net- work” on page 41 for details.

1. Download configuration example from the CD-ROM included with your SmartNode device or from the Patton Web server at www.patton.com/voip

LAN

3. Load configuration onto the SmartNode

2. Modify the configuration as needed

	240V
	- Hz)
100-60
(501	AMP

00:A0:BA:00:04:10NIC ADDRESS

Activity	Console
	Reset

Status Expansion

0/0

ETH

0/1

ETH

	240V
	- Hz)
100-60
(501	AMP

WAN (ETH 0/0)

LAN (ETH 0/1)

Internet or

WAN (optional)

Figure 16. Loading the configuration

Note You can manually configure the SmartNode. You do not have to load a configuration file.

1. Configure IP address

Factory-default IP settings

Both Ethernet interfaces are activated upon power-up. The LAN interface ETH 0/1 (LAN) provides a default DHCP server. The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 9. Both Ethernet interfaces are activated upon power-up. LAN interface ETH 0/1 (LAN) pro- vides a default DHCP server.

Table 9. Factory default IP address and network mask configuration

	IP Address	Network Mask
WAN interface Ethernet 0 (ETH 0/0)	DHCP	DHCP
LAN interface Ethernet 1 (ETH 0/1)	192.168.1.1	255.255.255.0(/24)
DHCP IP address range	192.168.1.10 - 192.168.1.19	255.255.255.0(/24)

If these addresses match with those of your network, go to section “2. Connecting the SmartNode to the net- work” on page 41. Otherwise, refer to the following sections to change the addresses and network masks.

1. Configure IP address 38