ASSEMBLE THE BASE

 

Manifold Weldment

 

 

 

GG-4084 thru GG-4084-46

 

Imperial #68F

 

 

 

 

1/4" NPT x 3/8" O.D.

 

 

 

 

Tube Straight Connector

 

Orifice Spud

 

 

 

X-4026

 

 

 

Mounting Clamp

 

 

 

 

GG-3052 thru GG-3052-3

 

 

Test Plug

 

 

 

 

 

3/8" x 3/8" x 1/4" Tee

 

 

 

 

(2) 1/4" Street Elbow

 

 

3/8" Pipe Cap

 

1/4" X 1-1/2"

 

 

Pipe Cap

1/4" x 1/8"

3/8" Thermopilot

3/8" x 1/4" Elbow

(38 mm) long Nipple

 

Hex Bushing

 

Valve(s) H17CA

 

Ignition Control & Relay

 

 

 

 

Mounting Box Assembly

 

 

 

 

(Standard HSP System, X-3011-3)

Imperial #69F Elbow

PB-H91BG-2 or

(2) 5/16"-18 x 3/4" (19mm) long

(Other panels mounted on

H-V8046C

jacket front, left side)

1/8" NPT x 1/4" O.D. Tubing

Pilot Gas Valve

Square Head Set Screw

Figure 2.5: Typical Gas Manifold and Pilot Line Assembly

4.Place only the Burners with pilots mounted in the locations given in Table 2.2. Install the Burners by slipping the opening on the front of the burner over the orifice adapter and slipping the pin on the end of the burner into the hole in the Burner Support Channel directly opposite the orifice.

5.Cut and fit the 1/4" aluminum tubing provided from the pilot gas shut-off device(s) to the pilot burners.

6.Do not install the remaining burners until the Boiler Sections are installed.

12

Page 14
Image 14
PB Heat 211A manual Typical Gas Manifold and Pilot Line Assembly