C1629M-F (3/08) 15
Figure 8. Product Serial Number Label
RACK MOUNTING
The DVR5300 mounts into an industry-standard 19-inch (48 cm) equipment rack. The DVR5300 occupies 3 RU (rack units) of vertical rack space
(5.25 inches or 13.3 cm). The hardware necessary to mount the DVR5300 into a rack is supplied with the unit.
The rack must meet the following requirements:
• 19-inch (48 cm) EIA-310-D compliant (rear column required)
• Rack column depth: 24 to 30 inches (61 to 76 cm)
• Column-mounting hole provisions: 10-32 UNF-2B threaded holes or square window holes on front and rear columns
• Door systems are acceptable. Front doors must have at least 2 inches (5.1 cm) between the DVR5300 front bezel and the inside of the door.
Rear doors may only be used on rack columns that are more than 26 inches (66 cm) deep.
To install the DVR5300 in a rack:
NOTE: Figure4 on page 11 identifies each piece of hardware for this procedure.
1. If chassis mounting brackets are not attached: Attach one chassis mounting bracket to each side of the DVR5300. Use six 10-32x 0.25-inch
Phillips pan head screws for each bracket.
WARNINGS:
• Secure the front and rear screws to the support rails.
• Make sure the DVR5300 is level.
• Slots and openings in the cabinet provide ventilation to prevent the unit from overheating. Do no t block these openings. Never place
the unit near or over a radiator or heat register. When placing the unit in a rack, be sure to provide proper ventilation.
MODEL
FREQ
50/60HZ
Sample Text
AMPS
VOLTS
Sample Text
REV
Sample Text
03267-39-0020
MFG BY PELCO, CLOVIS, CA
Model
SN
Audio/Video Apparatus
91KK
MADE IN USA
PRODUCT LABEL