Pelco C1629M-F - page 17

C1629M-F (3/08) 17

Figure 11. Inserting Cage Nuts

5. Attach one support rail assembly to the equipment rack in the desired location (refer to Figure 12):

NOTE: The support rail assemblies are identical and may be used on either the right or left side of the rack.

a. Position the ear of the front-mount rail against the front of the equipment rack. Align the top and bottom holes in the ear of the rail

with the threaded holes (or cage nuts) in the rack.

b. Using two 10-32 x 0.5-inch Phillips flat head screws, attach the ear of the rail to the front of the rack. Insert the screws from the

outside of the rack, pointing toward the back of the rack.

c. Adjust the rails to the correct depth of the equipment rack by sliding the rear-mount rail to the back of the equipment rack.

d. Position the ear of the rear-mount rail against the rear exterior of the equipment rack. Align the top and bottom holes in the ear of the

rail section with the threaded holes (or cage nuts) in the equipment rack.

e. Using two 10-32 x 0.75-inch Phillips pan head screws, attach the ear of the rail to the rear of the rack. Insert the screws from the

outside of the rack, pointing toward the front of the rack.

ALIGN

ALIGN

FRONT-MOUNT RAIL REAR-MOUNT RAIL

CAGE NUT

CAGE NUT

Contents

Main Page Contents List of Illustrations Page Regulatory Notices Video Quality Caution FRAME RATE NOTICE REGARDING USER-SELECTED OPTIONS Description FEATURES MODELS OPTIONAL ACCESSORIES Before You Begin PARTS LIST Qty Description USER SUPPLIED PARTS PACKAGE CONTENTS - OR - Figure 3. Accessory Pack SHOWN ACTUAL SIZE Figure 4. Rack Mount Kit ACCESSORY PACK APPLICATION SCENARIOS Figure 6. Security Network with a DVR5324, ENC5308s, and CM9700 Matrix Switch CM9760-KBD C1629M-F (3/08) 13 CM9700 SERIES Equipment Placement and Rack Mounting UNPACKING THE DVR5300 PRODUCT SERIAL NUMBER LABEL PLACEMENT RACK MOUNTING Page Page Page Page Page Hard Drive Array Installation INSTALLING HARD DRIVE CARRIERS Page Page Connections CONNECTING POWER CONNECTING ENC5300 SERIES VIDEO ENCODERS CONNECTING VIDEO ENCODERS TO THE DVR5300 CONNECTING TO THE NETWORK CONNECTING SERIAL PTZ DEVICES 28 C1629M-F (3/08) PIN 1 PTZ DEVICE 1 PTZ DEVICE 2 STRAIGHT CABLE TWISTED PAIR POWERING UP THE DVR5300 SYSTEM Operation FRONT PANEL CONTROLS AND INDICATORS UNIT STARTUP UNIT SHUTDOWN Appendix A: Expanding Video Storage INSTALLING A SINGLE SEB5100 UNIT (CABLE) INSTALLING MULTIPLE SEB5100 UNITS (SWITCH) Page Appendix B: Replacing a Hard Drive Page Page Appendix C: Replacing a Power Supply Page Appendix D: Installing an Uninterruptible Power Supply (UPS) Appendix E: Replacing the Operating System Drive Appendix F: Troubleshooting POWER SUPPLY PROBLEMS Specifications SYSTEM VIDEO/AUDIO NETWORK AUXILIARY INTERFACES ENVIRONMENTAL PHYSICAL STANDARDS/ORGANIZATIONS Page PRODUCT WARRANTY AND RETURN INFORMATION