24 C1629M-F (3/08)
ConnectionsFamiliarize yourself with the DVR5300 rear panel before connecting any equipment to the unit.
Figure 20. Rear Panel Layout
CONNECTING POWER
The DVR5300 is equipped with two hot-swappable power supplies. These autoranging power supplies adapt automatically to voltages between
100 VAC and 240 VAC (50/60 Hz).
You should also install an uninterruptible power supply (UPS) (not supplied). UPS devices maintain a limited amount of backup battery power in
case the main power fails. Refer to Appendix D: Installing an Uninterruptible Power Supply (UPS) on page41 for more information.
NOTE: Connect each power supply to a different branch circuit. This ensures optimal performance, reduces possible video los s, and reduces
power leakage to a safe level.
To connect power to the DVR5300:
1. Connect one of the supplied US, European, or UK standard power cords to the back of the primary power supply’s power connector.
2. Connect the other end of this power cord to the appropriate power source.
3. Connect the other supplied US, European, or UK standard power cord to the back of the secondary power supply’s power connector.
4. Connect the other end of this power cord to the appropriate power source.
When connected, the power supply status indicators glow solid red. As soon as the unit starts, the indica tors glow solid green. During operation,
if either indicator is dark or glows red, there is a problem with the power supply (refer to Appendix F: Troubleshooting on page 4 3 for more
information).
NOTE: Do not power up any DVR5300 system component (ENC5300, network, camera control) until you have connected all components.
ìPrimary Power Supply rPrimary Network Connector
îSecondary Power Supply sSecondary Network Connector
ïPower Supply Status Indicators tSerial Camera Control Connector (RJ-45)
ñENC5300 USB Ports uUSB 2.0 Port (for UPS)
óReserved
MODEL
FREQ
50/60HZ
Sample Text
AMPS
VOLTS
Sample Text
REV
Sample Text
03267-39-0020
MFG BY PELCO, CLOVIS, CA
Model
SN
Audio/VideoApparatus
91KK
MADE IN USA