Pelco C1629M-F - page 35

C1629M-F (3/08) 35
INSTALLING ADDITIONAL SEB5100 UNITS (EXISTING SWITCH)
To add an SEB5100 unit to an existing DVR5300 with a Gigabit Ethernet switch:
1. Connect one end of a UTP cable to a free RJ-45 port on the switch. Use a standard Cat5e or better UTP cable wi th RJ-45 connectors.
2. Connect the other end of the UTP cable to the secondary network connector on the rear panel of the new SEB5100.
NOTE: Do not connect the UTP cable to the primary network connector .
3. Power up the new SEB5100 if necessary (refer to the SEB5100 Series Installation manual for more information).
The DVR5300 automatically recognizes the new SEB5100 unit within two minutes and puts it into service.