Pelco C2900M-B(1/03 manual Quick Installation Guide, Connecting a Camera or Monitor

QUICK INSTALLATION GUIDE

Follow the next six steps for the fastest way to get your product operating.

STEP 1: CONNECTING A CAMERA OR MONITOR

￿

TRANSMITTER

VIDEO1

VIDEO2

VIDEO3

VIDEO4

AUDIO

ALARM

ALARM

INPUTS

OUTPUTS

COM

5

1

2

3

4 +5V

1

2

3

4

POWER

IN

OUT

+

+

+

+

￿

75 OHM ON

GND

GND

RS232/422/485

10/100 BASE-T

12V~0.8A

￿

RECEIVER

HANDSET

VIDEO-OUT

TRANSP.DATA

AUDIO-OUT

￿

Key:

1= Cameras or other video sources with composite PAL or NTSC output

2= Video monitor with composite PAL or NTSC input

3= NET104A transmitter

4 = NET101R/RA Receiver

Figure 3. Connecting Cameras Or Monitor

¥To connect the cameras, plug one end of a standard coaxial cable into a BNC connector (start with video 1) on the rear of the NET104A and the other end into the camera. You can use any video source with a composite PAL or NTSC output.

¥Set the DIP switches on the NET104A to position 75 OHM ON (down) to terminate the inputs when the video signal is not connected to additional video equipment through a T-connection.

¥To connect a monitor to the NET101R/R-A receiver, plug one end of a standard coaxial cable into the BNC connector on the NET101R/R-A and the other end into the monitor. You can use any PAL or NTSC video monitor with a composite PAL or NTSC input.

For more information about video sources and monitors, see the Hardware Installation section.

16 C2900M-B (1/03)