Pelco C2900M-B(1/03 Alarm input Off, Pin, Active low normally closed, Master Alarm Off, Input pin

		Table F. Alarm Settings (Continued)
Alarm input	off		If external sensors or simple contacts or switches will
pin 1-4			be used with the system, you need to select the
			alarm input.
			Click on to activate alarm triggering via an external
			sensor for the selected pin. Otherwise, click off.
			You also can specify whether the alarm is triggered
			by the voltage level active high (normally open) or
			active low (normally closed).
			In addition, you can enter a name (nine characters
			maximum) for the selected pin in the Name field.
Master Alarm	off		You can use alarm input 5 as a master alarm; for
input pin			example, if a key switch is used to arm the system.
			If you choose on, alarm input 5 must be active to
			enable all other alarms.
Camera follows	off		Select on to display the image of the corresponding
alarm input			camera automatically when an alarm is triggered.
			Choose off to keep the current camera display.
Alarm status	off		Current alarm activation status can be shown in the
			video image (similar to the name, date, and time
			stamping discussed in Table D).
			If configured to be on, the status of the activated
			alarms, namely, video, motion, and input, is shown in
			the upper left corner of the video image. Or, the
			display can be activated as soon as an alarm
			condition is reached (choose on alarm). This way, the
			video image corresponding to the alarm condition is
			clearly marked.
			Also, there is a choice to keep the status display,
			once an alarm has been triggered, even when the
			original cause of the alarm is no longer present
			(choose hold display), or to have the status display
			follow the alarm condition (choose hold off).
			(Continued on next page)

C2900M-B (1/03) 57