Pelco C2900M-B(1/03 manual Alarm Notification by E-MAIL, Record and Play Back the Display on a PC

ALARM NOTIFICATION BY E-MAIL

The e-mail feature lets you send an e-mail message to a recipient on any alarm event. This could be used to signal an alarm to people who cannot be reached with a video-based notification.

To activate this feature, enable at least one of the alarm inputs, configure a receiver e-mail address, and activate the Send Email button. Remember to configure a mail server and gateway IP addresses on the General Settings configuration page.

Now the system will send an e-mail to the specified recipient on every alarm event. There will be a timeout of at least 30 seconds before the same alarm event generates another e-mail message.

The e-mail will contain the status of the four alarm inputs so you can see which event triggered the e-mail.

RECORD AND PLAY BACK THE DISPLAY ON A PC

Live video control pages let you record the camera display on a PCÕs hard drive and play it back later. The file is recorded on the hard drive of the PC on which you are viewing the picture. The controls are a row of buttons beneath the screen.

NOTE: Audio is not saved to the AVI file. Consequently, there is no audio on playback.

Ð These buttons jump the display to the beginning or ending of the recording in playback mode.

Ð These buttons incrementally move the display backward and forward while the display is paused in playback mode.

Ð This button stops the recording or playback.

Ð This button pauses the recording or playback.

Ð This button plays the recording.

AVI

Ð This button starts the recording.

Ð This button is used to designate a location for saving the recording.

Ð This button is used to load a recorded file for playback.

C2900M-B (1/03) 71