Pelco C2900M-B(1/03 Receiver email Empty, Idle state Open, Current or closed N.C. at zero current

	Table F. Alarm Settings (Continued)
Receiver email	empty	If applicable, enter the e-mail address where you
address		want an e-mail sent in the event of an alarm.
Idle state	open	You can configure the switching behavior of each
		built-in relay output at idle: open (N.O. at zero
		current) or closed (N.C. at zero current).
Operating mode	Bistable	Select an operating mode for each relay.
		¥ When you select the default Bistable mode, the
		relay will stay in the idle or active state for an
		indefinite period. (For example, select Bistable if
		a floodlight activated by an alarm is to remain
		switched on at the end of the alarm.)
		¥ When you select Monostable mode, the relay
		automatically falls back to the idle state after a
		predefined period expires. (For example, select
		Monostable 10s if a siren triggered by an alarm is
		to sound for a period of 10 seconds.)
Relay follows	None	If necessary, select a particular event from the pull-
		down menu that will trigger the relay. A typical
		application is having the relay following the status of
		the connection; for example, to power peripheral
		equipment or even the camera itself. Select from the
		following:
		¥ Motion alarm: Triggering by motion alarm
		¥ Input pin: Triggering by external alarm sensor
		¥ Video loss: Triggering by video signal alarm
		¥ Connection: Triggering at each connection setup
		¥ Remote input pin: Triggering by switching
		contact of the remote station
		¥ None: No relay triggering by events
Relay Names	Relay 1-4	Assign a relay name to each output.
Trigger Relay	n/a	Clicking the appropriate Relay button switches that
		relay by hand. Typical applications are opening
		remote doors or operating lights.

C2900M-B (1/03) 59