404 PLASTER RING INSTALLATION

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the cover from the back box.

2.Pull the cable and wires into the cover. Use three 6-32 x 0.75-inch Phillips pan head screws (supplied) or two 8-32 x 0.75-inch Phillips pan head screws (supplied) to attach the cover to an installed 404 plaster ring. Use stainless steel hardware when installing the system outdoors.

3.Install the camera module into the back box before installing the back box into the cover. Rotate the camera module to access the mounting holes inside the back box (refer to Camera Module on page 19 for more information).

4.Connect the cable and wires (refer to Wiring Tables on page 16 for information).

5.Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

CEILING/

WALL

404 PLASTER RING (NOT SUPPLIED)

COVER

6-32 X 0.75-INCH OR 8-32 X 0.75-INCH

PHILLIPS PAN

HEAD SCREWS (SUPPLIED)

BACK BOX

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 7. 404 Plaster Ring Installation

14

C3432M-G (4/09)

Page 14
Image 14
Pelco IP110 manual Plaster Ring Installation