Camera Module
The IP110 Series Camclosure camera module includes the camera, camera bracket, and heater board. To perform most camera adjustments, you must remove the module from the back box.
Use the following instructions to install or remove the camera module.
WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting the camera. This applies to all models.
CAMERA ORIENTATION
The camera module is configured for ceiling mounting at the factory. For wall mounting, you must change the camera orientation or the video image will be upside down.
To change the camera orientation (refer to Figure 12):
1.Remove the camera module from the back box (if necessary).
2.Remove the tilt adjustment screw and lock washer from each side of the camera.
3.Carefully rotate the camera
4.Reinstall the tilt adjustment screw and lock washer on each side of the camera.
5.Verify the camera orientation.
CEILING MOUNT (DEFAULT)
BOTTOM
OF CAMERA
TILT ADJUSTMENT
SCREW AND
LOCK WASHER
WALL MOUNT
TOP OF
CAMERA
TILT ADJUSTMENT
SCREW AND
LOCK WASHER
Figure 12. Camera Orientation
19 |
