MODULE INSTALLATION

To install the camera module into the back box:

1.Plug the camera (10-pin), heater board (4-pin), and service (3-pin) connectors into the back box (refer to Figure 13).

HEATER

CONNECTOR

SERVICE

CONNECTOR

CAMERA

CONNECTOR

Figure 13. Back Box Connectors

2.Make sure the tabs on the camera bracket and the service connector are pointing out of the enclosure and away from the ceiling or wall.

3.Gently squeeze the bracket, place it against the groove inside the back box, and then gently release (refer to Figure 14).

BRACKET

Figure 14. Camera Module Bracket

20

C3432M-G (4/09)

Page 20
Image 20
Pelco IP110 manual Module Installation, Camera Module Bracket