Cover and Back Box Installation

The IP110 Series Camclosure integrated camera system mounts only to a surface. It can be wired through the cover into a surface, electrical box, plaster ring, or through a side conduit opening.

NOTE: A flash mount adaptor ring is available. Refer to the IP110-F Flush Mount Adaptor Installation manual (C2238M) for installation instructions.

BASIC SURFACE INSTALLATION

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the cover from the back box.

2.Cut out the hole for the cable and wiring. Pull the cable and wires through the mounting surface and then through the hole of the cover.

3.Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware when installing the system outdoors.

4.Install the camera module into the back box before installing the back box into the cover. Rotate the camera module to access the mounting holes inside the back box (refer to Camera Module on page 19 for more information).

5.Connect the cable and wires (refer to Wiring Tables on page 16 for information).

6.Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

COVER

MOUNTING SCREWS (NOT SUPPLIED)

8-32 X 0.375-INCH

BACK BOX

PHILLIPS PAN HEAD

 

SCREWS WITH WASHERS

 

(SUPPLIED)

 

Figure 5. Basic Surface Installation

12

C3432M-G (4/09)

Page 12
Image 12
Pelco IP110 manual Cover and Back Box Installation, Basic Surface Installation