Manuals / Pentax / Cell Phone / Carrying Case

Pentax PLP-602R, PLP-601R instruction manual Battery check key, Remaining battery display lamp

Models: PLP-602R

1 44

Download 44 pages 47.25 Kb

Page 18

(2) Battery check key

(2) Battery check key

Off level display lamp

		OFF
		LEVEL
MANUAL	BATTERY
MODE	CHECK	POWER
		ON
		OFF

Battery check key

1The consumption status of a battery can be confirmed by the remaining battery display lamp when the battery check key is pressed after turning on the power supply.

2The remaining battery display lamp is turned off about

15 seconds later after the battery check key is pressed.

Remaining battery display lamp

Turning on 3 green lamps

Workable enough.

Turning on 2 green lamps

Turning on 1 green lamp

Blink of 1 red lamp

Remaining capacity is little. Prepare the spare battery.

Battery is to be replaced.

Replace the battery.

Turning on 1 red lamp

NOTE:

•When 4 pcs rechargeable batteries type D are used, only 2 green lamps are turned on even if they are fully charged.

18

Image 18

Pentax PLP-602R, PLP-601R instruction manual Battery check key, Remaining battery display lamp

Contents

Manual Total Construction SolutionsInstruction Instruction ManualPage Safety Precautions must be followed Distinctive DisplaysLaser beam Equivalent to class 2 Laser level Precautions Page in or near the airport etc. and so correct measurement is sometimes not performed near these places. In these cases, please measure again after stopping or cutting these modulated light or wave etc Page Page Maintenance and adjustment CONTENTSafety Precautions Precautions Specifications1.1 Standard configuration 1. For proper use of the instrumentCenter mark 1.2 DescriptionBattery cap Top handlePower Switch Buzzer SwitchAccuracy Switch LCD Display1.3 Unpacking Taking the instrument out of the carrying casePutting the instrument into the carrying case 1.4 Battery insertion Battery insertion for the instrumentBattery insertion for the detector LS6 Detector 2.1 Keypad 1 Power supply key2. Display and Keypad 2.2 Role of keys2 Battery check key Remaining battery display lamp3 Auto/manual change key 4 Switching the rotation speed From 300 to 600 rpm2.3 Warning display MANUAL MODEOFF LEVEL BATTERY CHECKPOWER ON OFF 3. Preparation for measurement 1.1 Setting up the tripodSelection of the place to set up the tripod Arranging the tripodSetting up the tripod 3.2 Setting up the instrument Mounting on the tripodInstrument Tripod head Center screw Installing the rod adapter LA6 LS6 detector 3.3 Arranging the detectorRod Adapter Fixing screw Detector 4. Measurement 4.1 Operating the instrumentStarting the operation Power switch 4.2 Operating the detector LS6Selecting the reference level detecting accuracy High accuracy detectionLow accuracy detection ON or OFF of the beam reception buzzer Illuminating the displayDetecting the reference level Direct marking Plain rod markingPlain rod marking Reading the staff Staff Index Rod AdapterStains on the main body 5. Maintenance5.1 Maintenance after use Stains on the glass surfaceHandling the battery 5.2 Check and adjustment of the datum point Check8 If more than ± 5 mm, proceed to the following Adjustment procedure Manual mode display lamp 5.3 TroubleshootingContent PLP-601 / PLP-602 / PLP-601R / PLP-602RRotor ContentDetector LS6 DisplayDETECTOR LS6 6. SpecificationsINSTRUMENT PLP-601R / PLP-602R 300rpm / 600rpm can be switched1 Specifications of Laser Radiation 7. Notice to the user of this productPage Page Page Total Surveying Solutions Printed in BelgiumJapan Surveying Instruments Manufacturers’ Association