Manuals / Pentax / Cell Phone / Carrying Case

Pentax PLP-601R, PLP-602R ON or OFF of the beam reception buzzer, Illuminating the display

Models: PLP-602R

1 44

Download 44 pages 47.25 Kb

Page 29

[ON or OFF of the beam reception buzzer]

[ON or OFF of the beam reception buzzer]

Push the beam reception buzzer switch to select either the buzzer sounding or silenced.

6

[Illuminating the display]

1Push the illumination switch to illuminate the display.

2 Pushing the switch again turns off the illumination.

6

NOTE:

•For either the buzzer sounding or silencing to be selected, check with the mark in the liquid crystal display (see the figure on the above).

•The buzzer sounding/silencing alternates each time the buzzer switch is pushed.

•The buzzer sounding is initiated when the power turns on.

•The illumination turns off automatically if no laser beam is received and any switch is not operated for about one minute.

To illuminate the display again, push the illumination switch once more.

29

Image 29

Pentax PLP-601R, PLP-602R instruction manual ON or OFF of the beam reception buzzer, Illuminating the display

Contents

Instruction Total Construction SolutionsManual Instruction ManualPage Distinctive Displays Safety Precautions must be followedLaser beam Equivalent to class 2 Laser level Precautions Page in or near the airport etc. and so correct measurement is sometimes not performed near these places. In these cases, please measure again after stopping or cutting these modulated light or wave etc Page Page Safety Precautions Precautions CONTENTMaintenance and adjustment Specifications1. For proper use of the instrument 1.1 Standard configurationBattery cap 1.2 DescriptionCenter mark Top handleAccuracy Switch Buzzer SwitchPower Switch LCD DisplayPutting the instrument into the carrying case 1.3 UnpackingTaking the instrument out of the carrying case Battery insertion for the instrument 1.4 Battery insertionBattery insertion for the detector LS6 Detector 2. Display and Keypad 1 Power supply key2.1 Keypad 2.2 Role of keysRemaining battery display lamp 2 Battery check key3 Auto/manual change key From 300 to 600 rpm 4 Switching the rotation speedOFF LEVEL BATTERY CHECKPOWER ON OFF 2.3 Warning displayMANUAL MODE Selection of the place to set up the tripod 1.1 Setting up the tripod3. Preparation for measurement Arranging the tripodSetting up the tripod Instrument Tripod head Center screw 3.2 Setting up the instrumentMounting on the tripod Rod Adapter Fixing screw Detector Installing the rod adapter LA6 LS6 detector3.3 Arranging the detector Starting the operation 4. Measurement4.1 Operating the instrument 4.2 Operating the detector LS6 Power switchLow accuracy detection Selecting the reference level detecting accuracyHigh accuracy detection Illuminating the display ON or OFF of the beam reception buzzerDetecting the reference level Plain rod marking Direct markingPlain rod marking Staff Index Rod Adapter Reading the staff5.1 Maintenance after use 5. MaintenanceStains on the main body Stains on the glass surfaceHandling the battery Check 5.2 Check and adjustment of the datum point8 If more than ± 5 mm, proceed to the following Adjustment procedure Content 5.3 TroubleshootingManual mode display lamp PLP-601 / PLP-602 / PLP-601R / PLP-602RDetector LS6 ContentRotor DisplayINSTRUMENT PLP-601R / PLP-602R 6. SpecificationsDETECTOR LS6 300rpm / 600rpm can be switched7. Notice to the user of this product 1 Specifications of Laser RadiationPage Page Page Japan Surveying Instruments Manufacturers’ Association Total Surveying SolutionsPrinted in Belgium