Pentax PLP-602R, PLP-601R instruction manual Operating the detector LS6, Power switch

4.2 Operating the detector: LS6

[Power switch]

1Push the power switch to turn on the power to the detector.

2Pushing the power switch again turns off the power.

6

NOTE:

•The liquid crystal displays all light up as shown in the above figure with the power switch pressed. This permits checking for any defects in the liquid crystal display.

•The battery’s remaining capacity is always indicated with the power turned on. Check when to replace the battery, referring to the figure on the above.

•The power turns off automatically if no laser beam is received and any key not operated for about ten minutes. To turn on the power again, push the power key once again.

27