Manuals / Pentax / Cell Phone / Carrying Case

Pentax PLP-601, PLP-602R Preparation for measurement, Setting up the tripod, Arranging the tripod

Models: PLP-602R

1 44

Download 44 pages 47.25 Kb

Page 22

3. Preparation for measurement

3. Preparation for measurement

1.1 Setting up the tripod

[Arranging the tripod]

1Prepare the normal tripod for Level instrument.

2The dome head type and elevation type tripod for Level instrument can be used.

[Selection of the place to set up the tripod]

Be sure to select a place where the job will not be interrupted and the instrument can be set to have almost same distance to each point to be measured.

Nearly horizontal

Extraction

22

Image 22

Pentax PLP-602R, PLP-601R instruction manual Preparation for measurement, Setting up the tripod, Arranging the tripod

Contents

Manual Total Construction SolutionsInstruction Instruction ManualPage Safety Precautions must be followed Distinctive DisplaysLaser beam Equivalent to class 2 Laser level Precautions Page in or near the airport etc. and so correct measurement is sometimes not performed near these places. In these cases, please measure again after stopping or cutting these modulated light or wave etc Page Page Maintenance and adjustment CONTENTSafety Precautions Precautions Specifications1.1 Standard configuration 1. For proper use of the instrumentCenter mark 1.2 DescriptionBattery cap Top handlePower Switch Buzzer SwitchAccuracy Switch LCD DisplayTaking the instrument out of the carrying case 1.3 UnpackingPutting the instrument into the carrying case 1.4 Battery insertion Battery insertion for the instrumentBattery insertion for the detector LS6 Detector 2.1 Keypad 1 Power supply key2. Display and Keypad 2.2 Role of keys2 Battery check key Remaining battery display lamp3 Auto/manual change key 4 Switching the rotation speed From 300 to 600 rpmOFF LEVEL BATTERY CHECKPOWER ON OFF 2.3 Warning displayMANUAL MODE 3. Preparation for measurement 1.1 Setting up the tripodSelection of the place to set up the tripod Arranging the tripodSetting up the tripod Mounting on the tripod 3.2 Setting up the instrumentInstrument Tripod head Center screw 3.3 Arranging the detector Installing the rod adapter LA6 LS6 detectorRod Adapter Fixing screw Detector 4.1 Operating the instrument 4. MeasurementStarting the operation Power switch 4.2 Operating the detector LS6High accuracy detection Selecting the reference level detecting accuracyLow accuracy detection ON or OFF of the beam reception buzzer Illuminating the displayDetecting the reference level Plain rod marking Direct markingPlain rod marking Reading the staff Staff Index Rod AdapterStains on the main body 5. Maintenance5.1 Maintenance after use Stains on the glass surfaceHandling the battery 5.2 Check and adjustment of the datum point Check8 If more than ± 5 mm, proceed to the following Adjustment procedure PLP-601 / PLP-602 / PLP-601R / PLP-602R 5.3 TroubleshootingContent RotorRotor ContentDetector LS6 DisplayDETECTOR LS6 6. SpecificationsINSTRUMENT PLP-601R / PLP-602R 300rpm / 600rpm can be switched1 Specifications of Laser Radiation 7. Notice to the user of this productPage Page Page Printed in Belgium Total Surveying SolutionsJapan Surveying Instruments Manufacturers’ Association