Manuals / Pentax / Cell Phone / Carrying Case

Pentax PLP-602R, PLP-601R instruction manual Detecting the reference level

Models: PLP-602R

1 44

Download 44 pages 47.25 Kb

Page 30

[Detecting the reference level]

At the measuring point, set the position of the detector nearly to the height of the beam emitting aperture of the instrument.

Position the detector where the buzzer sound (or the beam reception display appears) by directing the detecting display nearly toward the instrument and moving the detector up and down.

Move the detector up and down again according to the beam reception display (or the buzzer) and obtain the reference level.

Move the detector down as it is positioned high.

The buzzer sound beeps at short intervals.

This is the reference position.

The buzzer sound beeps continuously.

Move the detector up as it is positioned low.

The buzzer sounds lasting beeps intermittently.

NOTE:

•When detecting the reference level, the detector should face the instrument in the range of about 40°, to the right and left from the front.

30

Image 30

Pentax PLP-602R, PLP-601R instruction manual Detecting the reference level

Contents

Manual Total Construction SolutionsInstruction Instruction ManualPage Safety Precautions must be followed Distinctive DisplaysLaser beam Equivalent to class 2 Laser level Precautions Page in or near the airport etc. and so correct measurement is sometimes not performed near these places. In these cases, please measure again after stopping or cutting these modulated light or wave etc Page Page Maintenance and adjustment CONTENTSafety Precautions Precautions Specifications1.1 Standard configuration 1. For proper use of the instrumentCenter mark 1.2 DescriptionBattery cap Top handlePower Switch Buzzer SwitchAccuracy Switch LCD Display1.3 Unpacking Taking the instrument out of the carrying casePutting the instrument into the carrying case 1.4 Battery insertion Battery insertion for the instrumentBattery insertion for the detector LS6 Detector 2.1 Keypad 1 Power supply key2. Display and Keypad 2.2 Role of keys2 Battery check key Remaining battery display lamp3 Auto/manual change key 4 Switching the rotation speed From 300 to 600 rpm2.3 Warning display MANUAL MODEOFF LEVEL BATTERY CHECKPOWER ON OFF 3. Preparation for measurement 1.1 Setting up the tripodSelection of the place to set up the tripod Arranging the tripodSetting up the tripod 3.2 Setting up the instrument Mounting on the tripodInstrument Tripod head Center screw Installing the rod adapter LA6 LS6 detector 3.3 Arranging the detectorRod Adapter Fixing screw Detector 4. Measurement 4.1 Operating the instrumentStarting the operation Power switch 4.2 Operating the detector LS6Selecting the reference level detecting accuracy High accuracy detectionLow accuracy detection ON or OFF of the beam reception buzzer Illuminating the displayDetecting the reference level Direct marking Plain rod markingPlain rod marking Reading the staff Staff Index Rod AdapterStains on the main body 5. Maintenance5.1 Maintenance after use Stains on the glass surfaceHandling the battery 5.2 Check and adjustment of the datum point Check8 If more than ± 5 mm, proceed to the following Adjustment procedure Manual mode display lamp 5.3 TroubleshootingContent PLP-601 / PLP-602 / PLP-601R / PLP-602RRotor ContentDetector LS6 DisplayDETECTOR LS6 6. SpecificationsINSTRUMENT PLP-601R / PLP-602R 300rpm / 600rpm can be switched1 Specifications of Laser Radiation 7. Notice to the user of this productPage Page Page Total Surveying Solutions Printed in BelgiumJapan Surveying Instruments Manufacturers’ Association