Philips DVD750VR owner manual CableAUDIOBox/SatelliteOUT, RF coaxial cable RF coaxial cable

H9421CD/DVD750(EN).pgs1-51.QX3 03.4.11 11:29 AM Page 10

10 Hookups (cont’d)

DVD/VCR to Cable Box or Satellite Receiver and TV

Using only basic RF coaxial cables

This connection will let you use the features of both theVCR and the DVD Player.

DVD/VCR

1Cable Signal

DVD/VCR VCR AUDIO OUT AUDIO IN

ANT-IN

L L

R R

ANT-OUT VIDEO OUT VIDEO IN

2		Y			Receiver
	OUT	CableAUDIOBox/SatelliteOUT
			DVD
	S-VIDEO OMPONENT AUDIO DIGITAL
		VIDEO OUT	OUT
		CB	L
IN				COAXIAL
		CR	R	OUT

75 ANT / CABLE

RF coaxial cable RF coaxial cable

3 TV’s ANTENNA IN Jack

Connections

1 Connect a Cable TV or Satellite signal to the DVD/VCR’s ANT-IN (Antenna In) jack.

2 Use an RF coaxial cable (as the one supplied) to con- nect the ANT-OUT (Antenna Out) jack on the DVD/VCR to the IN jack on the Cable Box/Satellite Receiver.

3 Use a second RF coaxial cable to connect the OUT jack on the Cable Box/Satellite Receiver to the ANTENNA IN jack on the TV.

Remember...

There are two ways to connect your Cable Box/Satellite Receiver to the DVD/VCR.With the connection on this page:

●You may watch one channel while recording another. Follow these steps:

1) Put the Cable Box/Satellite Receiver on the same channel as the DVD/VCR’s output channel (03 or 04).The DVD/VCR’s output channel is channel 3 when the DVD/VCR is new.To alternate it between 3 and 4, press and hold the (VCR) PLAY B button on the front of the DVD/VCR for 3-5 seconds during tape playback. For

details, see step 4 on page eight. Set the TV to the Cable Box/Satellite Receiver output channel (03 or 04).

2)Press VCR to put the DVD/VCR in VCR mode.The green VCR light will appear on the front of the DVD/VCR.

3)Press VCR/TV on the remote to choose VCR position.

4)Press SKIP3/CHo or SKIP /CHp to select the channel you want to record at the DVD/VCR. Press RECORD or RECORD to start the recording.

5)Press VCR/TV on the remote once to put the DVD/VCR in TV position.

6)Select the channel you want to watch at the Cable Box/Satellite Receiver.

●When you play a tape or Disc, make sure the Cable Box/Satellite Receiver is set to the DVD/VCR’s output channel (03 or 04).

Set the TV to the Cable Box/Satellite Receiver output channel (03 or 04).

Helpful Hints

•When you play a tape, make sure the Cable Box/Satellite Receiver is set to the same channel as the RF output channel of the DVD/VCR (03 or 04). Set the TV to the Cable Box/Satellite Receiver output channel (03 or 04).

•If your Cable Box or Satellite Receiver has Audio and Video Out jacks, use audio and video cables to connect them to the VCR AUDIO IN and VIDEO IN jacks on the rear of the DVD/VCR.You will not need the RF coaxial cable con- nection between the Cable Box/Satellite Receiver and the DVD/VCR as described at step 2.