Please note the color order

 

The colors of the jacks on the DVD Recorder must match those on the

 

TV (red-red/blue-blue/green-green). If they are not matched properly,

 

this could cause the color of the picture to be reversed or there could

Tip

be no picture at all.

5Use the supplied audio cable and plug one end into the OUT AUDIO LR jack at the back of the DVD Recorder (next to OUT COMPONENT VIDEO ) and the other into the red/white

Audio In jacks of the TV (usually called Audio in', 'AV in'. Please see your TV's instruction manual).

6Switch on the TV.

If necessary, set the TV to the Component Video channel.

If necessary, see the operating instructions for your TV. Or, go to channel zero on your TV, then keep changing channels down until you see the DVD Recorder screens (when the Recorder is on). This is not channel 3 or 4 as it would be if you used only the cable/antenna connection.

7Connect the mains jack 4MAINS at the back of the DVD Recorder with the power supply using the supplied power cable.

The most important features of the DVD Recorder will appear on the display.

After the initial installation is completed, this function will be switched off. How you switch on this function again, read in the chapter 'User preferences' in the section 'Standby'.

8

Press STANDBY/ON m on the recorder. '￿￿ ￿￿ ￿￿￿' will

appear on the display.

 

Switching TV and DVD Recorder to 'Progressive scan'

 

The factory settings of the DVD Recorder are set to 'Interlaced'. If you

 

selected the 'Progressive scan' connection during installation, you must

 

switch the 'Component Video output' of the DVD Recorder and, if

 

necessary, the 'Component Video input' of the TV to 'Progressive scan.'

 

Switching the TV

 

Please select 'Progressive scan' for the Component Video input on the

 

TV. If necessary, see your TV instruction manual.

 

If your TV is equipped with separate input jacks for Interlaced and

 

Progressive, connect the DVD Recorder to the jack that supports

 

'Progressive scan.'

Switching the DVD Recorder

1Disconnect the recorder's power cord.

2Hold down O on the DVD Recorder while reconnecting the power cord. 'PRO' (progressive scan) will appear on the display.

3If you want to switch back, repeat steps 1 and 2 . 'PRO' (progressive scan) will disappear from the display. The DVD

Recorder is switched to 'Interlaced.'

Tip

Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD recorder'.

ENGLISH

Connecting the DVD Recorder

13

 

Page 25
Image 25
Philips DVDR 75 manual Please note the color order, Switching TV and DVD Recorder to Progressive scan, Switching the TV