Philips DVDR 75 manual Connecting only with the antenna cable, Connecting the DVD Recorder

6Connect the mains jack 4MAINS at the back of the DVD Recorder with the power supply using the supplied power cable.

The most important features of the DVD Recorder will appear on the display.

After the initial installation is completed, this function will be switched off. How you switch on this function again, read in the chapter 'User preferences' in the section 'Standby'.

7	Press STANDBY/ON m on the recorder. '￿￿ ￿￿ ￿￿￿' will
	appear on the display.

Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD recorder'.

Connecting only with the antenna cable

USE THIS CONNECTIONN IF YOUR TV ONLY HAS A SINGLE ANTENNA IN JACK AND DOES NOT HAVE ANY AUDIO/VIDEO JACKS. Please observe that you must adjust the TV to the DVD-Recorder (channel 3 or 4).

Have the following cables ready:

an antenna cable (1, supplied), and a power cable (2, supplied).

1

2

3

Switch off your TV.

Remove the antenna or Cable TV signal from the antenna input jack of the TV. Insert it into the ANTENNA IN jack at the back of the DVD recorder.

Insert one end of the supplied antenna cable into the TV OUT jack at the back of the DVD Recorder and the other end into the antenna input jack at the back of the TV.

4Connect the mains jack 4MAINS at the back of the DVD Recorder with the power supply using the supplied power cable.

The most important features of the DVD Recorder will appear on the display.

After the initial installation is completed, this function will be switched off. How you switch on this function again, read in the chapter 'User preferences' in the section 'Standby'.

5

6

Press STANDBY/ON m on the recorder. '￿￿ ￿￿ ￿￿￿' will appear on the display.

Switch on your TV and select the channel used for DVD/VCR playback on your TV. Choose between channel 3 or 4.

16 Connecting the DVD Recorder