Specifications | Philips HDTP 8530, HDTP 8540 manual

13 Specifications

DUAL DVB-T/T2 FRONT END

RF INPUT

•2 RF tuners (w. internal splitter)

•Input frequency range: UHF470-862 (8 MHz bandwidth)

•Input signal level: -90 to -20 dBm

•Input impedance: 75 Ohms unbalanced

•Tuning step 166,66kHz

DVB-T DEMODULATOR

•Transmission mode: FFT 2k & 8k, MFN and SFN network supported

•Constellation: QPSK, 16-QAM & 64-QAM

•Guard interval: 1/4, 1/8, 1/16 & 1/32

•Mode: Non hierarchical

•Code rate: 1/2, 2/3, 3/4, 5/6 & 7/8

•Outer decoder: Reed Salomon (204, 188, 8)

DVB-T2 DEMODULATOR

•Transmission mode: FFT 1K, 2k, 4K, 8k, 8K EXT,16K, 16K EXT, 32K & 32K EXT

MFN and SFN network supported

•Constellation: QPSK, 16-QAM, 64-QAM & 256-QAM

•Guard interval: 1/4, 19/128, 1/8, 19/256, 1/16, 1/32 & 1/128

•Single and multiple-PLPs

•LDPC Code rate: 1/2, 3/5, 2/3, 3/4, 4/5 & 5/6

•Outer decoder: BCH

Data Port

ETHERNET 10/100BT

•Fully integrated IEEE 802.3/802.3u 10/100 base T-Physical layer

•Auto-negotiation 10/100

USB

•Host USB 2.0 High speed (480 Mbits/s)

Processor and Memories

•Processor: STi7105 - 800MIPS

•RAM memory 256 Mbytes

•Flash memory 64 Mbytes

•EEPROM emulated into Flash

2½’’ hard disk drive

•Capacity: the recording capacity of your recorder depends on the model.

•Noise under operation (typ.): <30dBA

Video Decoding

MPEG2

•Standard MPEG-2 MP@HL for 50 Hz

•Input rates (max): 15 Mbit/s

MPEG-4 Part 10 / H.264

•MPEG-4 AVC HP@L4 (HD) for 50 Hz

•Input rates (max): 20 Mbit/s for HP@L4

•MPEG-4 AVC HP@L3 (SD) for 50 Hz

•Input rates (max): 10 Mbit/s for HP@L3

•CABAC and CAVLC decoding

•Supports all intra/inter prediction modes and block sizes, I,P and B picture types

•Fidelity range extensions (8x8 Transforms, 8x8 Spatial Prediction Mode, Dynamic Quantization Matrix)

Audio Decoding

Stereo 2.0

•MPEG-1 layer I & II (Musicam)

•MPEG-2 layer II

•AAC

•Mode: Mono, stereo, joint stereo

•Sampling rates 32, 44.1 or 48 KHz

Multichannel 5.1

•DOLBY Digital (AC3)

•Mode: pass through and down mixing

•DOLBY Digital+ (E-AC3)

•Mode: pass through, transcoding Dolby Digital, and down mixing

•MP3 codec

Output Resolution Format

For HD broadcast

•1280x720 @ 50 Hz (progressive)

•1920x1080 @ 25 Hz (interlaced)

•Unscaled (original format) or scaled 576i, 720p and 1080p by set up menu

For SD broadcast

•720x576 @ 50 Hz interlaced

•Unscaled (original format) or scaled 720p and 1080i by set up menu

Format function on TV SCART

•4/3 and 16/9 with conversion Pan and Scan, Letter box

SD INPUT/OUTPUT

SCART (TV setup configuration)

•RGB out, PAL in/out, volume control Audio R/L, Fast blanking out, Slow blanking out

SCART (Recorder setup configuration)

•RGB in, PAL out, S-Video out, fixed volume Audio R/L, Slow blanking out

HDMI Output

HDMI 1.3 and HDCP 1.1

•VIDEO: YCrCb

•AUDIO

•2 channels PCM in case of MPEG1-layer II

•Dolby Digital or PCM in case of AC3 beat stream (*)

•Dolby Digital Plus, Dolby Digital or PCM in case of E-AC3 beat stream (*)

•(*) according of E(EDID) information

AUDIO Output

HiFi audio output

•Adjustable audio level

•Mono/Stereo in case of MPEG1-layer II

•Two channels down mixed in case of AC3, E-AC3, HEAAC audio stream

Coax S/PDIF

•Stereo audio setup:

•Fixed audio level -20 dBLKFS

•Two channels PCM in case of MPEG1-layer II or AAC stream

•Two channels PCM down mix in case of AC3/E-AC3/ HEAAC streams

•Multichannel audio setup:

•Fixed audio level -31 dBLKFS