Philips VR969/05 operating instructions Connecting to the mains supply, Some notes on operation

Warning !

In case this appliance is supplied with a Safety Standard Approved mains lead fitted with a non- rewireable 13 Amp mains plug which, if unsuitable for your socket, should be cut off and an appropriate plug fitted by a qualified electrician. The fuse and fuse holder must be removed from the plug as accidental insertion of the redundant plug into a 13 Amp socket is likely to cause an electrical hazard.

Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.

If it is necessary to change the fuse in the non-rewire- able plug, the correct type and rating (3 Amp ASTA or BSI ap-proved BS 1362) must be used and the fuse cover must be refitted. If the fuse cover is lost or damaged the lead and plug must not be used until a replacement is obtained. Replacement fuse cover should be obtained from your dealer.

If a non-rewireable plug or a rewireable 13 Amp (BS 1363) plug is used, it must be fitted with a

3 Amp ASTA or BSI approved BS 1362 fuse. If any other type of plug is used it must be protected by a 3 Amp fuse either in the plug or at the distribution board.

Important!

The wires in the mains lead are coloured in accordance with the following code:

BLUE	– NEUTRAL
BROWN	– LIVE

As the colours of the wires in the mains lead of your appliance may not correspond with the coloured marking identifying the terminals in your plug, proceed as follows:

Connect the BLUE coloured wire to plug termi- nal marked with the letter "N" or coloured black. Connect the BROWN coloured wire to the plug terminal marked with a letter "L" or coloured red. In no circumstance must any of the wires be connected to the terminal marked with a letter "E", earth symbol Á , coloured green or green and yellow.

Replacement mains lead can be obtained from your dealer.

ENGLISH

Connecting to the mains supply

RS 232

2 EXTERNAL / DEC.- AV 2

	AUDIO
L	L	1 EXTERNAL / EURO-AV 1
O	I
U		S-VHS OUT
T	N

RR

! Insert the female plug of the mains cable into the mains socket Ÿat the rear of the video recorder.

"Insert the other plug of the mains cable into the wall socket.

Your video recorder is now properly connected.

Some notes on operation

•The video recorder should permanently be connect- ed to the mains supply to enable programmed recordings and TV operation. The energy consump- tion is very low.

•The video recorder is automatically switched on when inserting a cassette (the zsymbol lights up in the video recorder display) or when pressing the rbutton.

8D 8W 88:88:8-:--

P		VPS		SVHS	STEREO I
	EI8	PDC	■ ■	z	• NICAM II
		DEC			LP MONO HiFi

•If the video recorder is not used for a few minutes, it is automatically switched off.

7