Section
02 Before You Start
Removing the front panel
1Press DETACH to release the front panel.
2Grab the front panel and remove. Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent perma- nent damage.
3Put the front panel into provided pro- tective case for safe keeping.
2Press RESET with a pen tip or other pointed instrument.
RESET button
Note
After completing connections or when you want to erase all memorized settings or return the unit to its initial (factory) settings, switch your engine ON or set the ignition switch to ACC ON before pressing RESET.
Attaching the front panel
%Replace the front panel by clipping it into place.
Resetting the microprocessor
Pressing RESET lets you reset the micropro- cessor to its initial settings without changing the bookmark information.
The microprocessor must be reset under the following conditions:
!Prior to using this unit for the first time after installation
!If the unit fails to operate properly
!When strange or incorrect messages ap- pear on the display
1 Turn the ignition switch OFF.
Feature demo mode
The feature demo automatically starts when you select the source OFF. The demo con- tinues while the ignition switch is set to ACC or ON. To cancel the feature demo, press and hold VOLUME/ATT. To restart the feature demo, press and hold VOLUME/ATT again. Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power.
Important
The red lead (ACC) of this unit should be con- nected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained.
14 En