Pioneer AVH-P5900D operation manual Selecting a cross-overfrequency, Available accessories

Section

04 Available accessories

3Touch a or b to select the speaker to be adjusted.

Each time you touch a or b selects the speak- er in the following order:

FRONT L (front speaker left)—CENTER (center speaker)—FRONT R (front speaker right)— REAR R (rear speaker right)—REAR L (rear

speaker left)—SUB WOOFER (subwoofer)

# You cannot select speakers whose size is set at OFF. (Refer to Setting the speaker setting on page 80.)

4Touch c or d to adjust the speaker out- put level.

Each time you touch c or d increases or de- creases the speaker output level. +10 to –10 is displayed as the level is increased or de- creased.

Note

To adjust the speaker output levels in this mode is the same as making the speaker output levels at TEST TONE. Both provide the same results.

Selecting a cross-over frequency

You can select a frequency, under which sounds are reproduced through the subwoo- fer. If the installed speakers include one whose size has been set to SMALL, you can select a frequency, under which sounds are repro- duced through a LARGE speaker or subwoo- fer.

1Touch NEXT on the DSP function menu.

2Touch CROSS OVER.

3Touch a or b to select the speaker to be adjusted.

Each time you touch a or b selects the speak- er in the following order:

FRONT (front speakers)—CENTER (center speaker)—REAR (rear speakers)—

SUB WOOFER (subwoofer)

4Touch c or d to select cross-over fre- quency.

Each time you touch c or d selects cross-over frequencies in the following order:

63—80—100—125—160—200 (Hz)

Note

Selecting a cross-over frequency is to set a cross- over frequency of the subwoofer’s L.P.F. (low-pass filter) and that of the SMALL speaker H.P.F. (high- pass filter). The cross-over frequency setting has no effect if the subwoofer is set to OFF and other speakers are set to LARGE or OFF.

Adjusting the speaker output levels using a test tone

This function allows you to easily get the over- all balance right among the speakers.

1Touch NEXT on the DSP function menu.

2Touch TEST TONE.

3Touch START to start the test tone out- put.

The test tone is outputted. It rotates from speaker to speaker in the following sequence at intervals of about two seconds. The current settings for the speaker over which you hear the test tone are shown in the display. FRONT L (front speaker left)—CENTER (center speaker)—FRONT R (front speaker right)— REAR R (rear speaker right)—REAR L (rear speaker left)—SUB WOOFER (subwoofer) Check each speaker output level. If no adjust- ments are needed, perform step 5 to stop the test tone.

82 En