Available accessories
!Set the front or rear speaker to LARGE if the speaker is capable of reproducing bass content, or if no subwoofer is installed.
1Touch NEXT on the DSP function menu.
2Touch SPEAKER SETTING.
3Touch a or b to select the speaker to be adjusted.
Each time you touch a or b selects the speak- er in the following order:
FRONT (front
SUB WOOFER
fer setting)
# You can switch to PHASE only when the sub- woofer has been set to ON.
4Touch c or d to select the correct size for the selected speaker.
Each time you touch c or d selects the size in the following order:
OFF
# You cannot select OFF, when FRONT (front
speakers) have been selected.
# You can select ON or OFF, when
SUB WOOFER (subwoofer) has been selected.
# You can switch REVERSE (reverse phase) or NORMAL (normal phase), when PHASE (subwoo- fer setting) has been selected.
Section
04
3 Touch a or b to select SUB WOOFER |
| |
(subwoofer). |
| |
Each time you touch a or b selects the speak- |
| |
er in the following order: |
| |
FRONT (front | Available | |
| ||
SUB WOOFER |
| |
fer setting) | accessories | |
4 Touch d to turn subwoofer output on. | ||
| ||
# To turn subwoofer output off, touch c. |
| |
5 Touch b and then touch c or d to se- |
| |
lect the phase of subwoofer output. |
| |
Touch d to select normal phase and |
| |
NORMAL appears in the display. Touch c to |
| |
select reverse phase and REVERSE appears in |
| |
the display. |
| |
Note |
| |
When playing a |
| |
Logic turned on, there may be occasions when |
| |
the following will occur: |
|
!No audio is outputted if the center speaker setting is SMALL or LARGE and no center speaker is installed.
!Audio is heard only over the center speaker if installed and the center speaker setting is SMALL or LARGE.
Correcting the subwoofer’s phase
If trying to boost the bass output of the sub- woofer doesn’t do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofer’s output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer.
1Touch NEXT on the DSP function menu.
2Touch SPEAKER SETTING.
Adjusting the speaker output levels
Speaker level can be adjusted finely by listen- ing to an audio output. First, use test tone to adjust the approximate speaker level, and then use this function to adjust finely.
1Touch NEXT on the DSP function menu.
2Touch SPEAKER LEVEL.
En 81