|
|
| Section |
Available accessories | 04 | ||
|
|
|
|
3Turn the ignition switch to ON or ACC. If the car’s air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto
TA and EQ.
# Press SOURCE to turn the source on if this unit is turned off.
4Select the position for the seat on which the microphone is placed.
Refer to Using the position selector on page
# If no position is selected before you start auto TA and EQ,
5Press SOURCE and hold until the unit turns off.
6Touch the screen to display the touch panel keys.
7Touch and hold EQ to enter the auto TA and EQ measurement mode.
8Plug the microphone into the micro- phone input jack on the
Available accessories
For details concerning operation, refer to the
9Touch START to start the auto TA and
EQ.
10Get out of the car and close the door within 10 seconds when the
The measurement tone (noise) is outputted from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about nine minutes.
# To stop auto TA and EQ, touch STOP.
# To cancel auto TA and EQ part way through, touch BACK or ESC.
11When auto TA and EQ is completed, Complete is displayed.
When correct measurement of car interior acoustic characteristics is not possible, an error message is displayed. (Refer to Under- standing auto TA and EQ error messages on page 92.)
12Touch ESC to cancel the auto TA and EQ mode.
En 87