Pioneer DEH-P7850BT Setting the rear output and subwoofer controller, Switching the feature demo

Initial Settings

1Use MULTI-CONTROL to select Brightness.

Brightness appears in the display.

2Push MULTI-CONTROL left or right to adjust the brightness level.

Each time MULTI-CONTROL is pushed left or right, brightness level increases or decreases.

0to 15 is displayed as the level is increased or

decreased.

# When dimmer is functioning, the brightness level can be adjusted 0 to 10.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (Rear SP :F.Range) or subwoo- fer (Rear SP :S/W) connection. If you switch the rear output setting to Rear SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speak- er connection (Rear SP :F.Range).

1Use MULTI-CONTROL to select S/W control.

S/W control appears in the display.

2Press MULTI-CONTROL to switch the rear output setting.

Pressing MULTI-CONTROL will switch be- tween Rear SP :F.Range (full-range speaker) and Rear SP :S/W (subwoofer) and that status

will be displayed.

# When no subwoofer is connected to the rear

output, select Rear SP :F.Range.

# When a subwoofer is connected to the rear output, set for subwoofer Rear SP :S/W.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output

Black plate (79,1)

Section

14

on (refer to Using subwoofer output on page	English
73).

!If you change this setting, subwoofer output in the audio menu return to the factory set- tings.

!Both rear speaker leads outputs and RCA rear

output are switched simultaneously in this setting.

Switching the sound muting/attenuation

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjust- ment is possible.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

1Use MULTI-CONTROL to select Mute. Mute appears in the display.

2Press MULTI-CONTROL to switch the tel- ephone muting/attenuation.

Pressing MULTI-CONTROL will switch be-

tween TEL ATT (attenuation) and TEL mute (muting) and that status will be displayed.

Switching the feature demo

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON.

1Use MULTI-CONTROL to select Demonstration.

Demonstration appears in the display.

2Press MULTI-CONTROL to turn the fea- ture demo on.

ON appears in the display.

En 79

<CRD4060-A/N>79