Pioneer DEH-P9850BT Use and care of the remote control, Feature demo mode, Installing the battery

Section

01 Before You Start

Feature demo mode

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON. Pressing DISPLAY during feature demo operation can- cels the feature demo mode. Press DISPLAY again to start the feature demo mode. Remem- ber that if the feature demo continues operat- ing when the car engine is turned off, it may drain battery power.

Use and care of the remote control

Installing the battery

Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus (–) poles pointing in the proper di- rection.

!When using for the first time, pull out the film protruding from the tray.

Black plate (10,1)

!Do not store the battery with metallic materi- als.

!In the event of battery leakage, wipe the re- mote control completely clean and install a new battery.

!When disposing of used batteries, please comply with governmental regulations or en- vironmental public institutions’ rules that apply in your country/area.

Using the remote control

Point the remote control in the direction of the front panel to operate.

!The remote control may not function prop- erly in direct sunlight.

Important

!Do not store the remote control in high tem- peratures or direct sunlight.

!Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedal.

WARNING

Keep the battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.

CAUTION

!Use only one CR2025 (3 V) lithium battery.

!Remove the battery if the remote control is not used for a month or longer.

!Do not recharge, disassemble, heat or dispose of the battery in fire.

!Do not handle the battery with metallic tools.

FUNCTION button and AUDIO button

You can also select the desired mode by FUNCTION button and AUDIO button on the remote control. But operation of FUNCTION button and AUDIO button on the remote con- trol differs from the operation of MULTI-CONTROL on the head unit. When op- erating the remote control, switch through the modes as described below to select the mode.

FUNCTION button operation

%Press FUNCTION to select the desired mode (e.g., built-in CD player).

Press FUNCTION repeatedly to switch be- tween the following modes:

10 En

<CRB2179-A/N>10