S002*_En
  !
    #
D3-4-2-1-3_B_En

Thank you for buying this Pioneer product.

Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference.

In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. However the method of connecting and operating the unit is the same.

K015 En

IMPORTANT

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

D3-4-2-1-1_A1_En

WARNING

This equipment is not waterproof. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture.



             

+$!)$)+ !!%$,'(*%%!- '( $' #)$$*#)'-$'' $#(*'))) %$,'(*%%!-+$!)$)',') (*# )

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.

, !!*(")()'&* '+$!)  $' ,' ))#$#)''%#!

IMPORTANT: THE MOULDED PLUG

This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to BS1362.

Check for the ASTA mark or the BSI mark on the body of the fuse.

If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.

If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.

If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows ;

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.

D3-4-2-1-2-2_B_En



"#%)!'%+%"!"'#!*!  &"(%&&(&'!"!' $(# !'  



$!)%)./''%)#/$%.0)%/(&!.0-!/*'!1!.+! -*0)/$!0)%/"*-1!)/%'/%*)/*%(+-*1!$!/ - %/%*)/'!./ (/-!-) (/!$

.% !



'*/.) *+!)%)#.%)/$!%)!/-!+-*1% ! "*-1!)/%'/%*)/*!).0-!-!'%'!*+!-/%*)*"/$!+-* 0/) /*+-*/!/%/"-*(*1!-$!/%)#*+-!1!)/"%-!$4- /$!*+!)%)#..$*0' )!1!-!

'*&! *-*1!-! 2%/$%/!(..0$.)!2.++!-. /'!'*/$.0-/%).*-3*+!-/%)#/$!!,0%+(!)/*)/$%&-+!/*-!    )

CAUTION

CAUTION

This product is a class 1 laser product, but this product contains a laser diode higher than Class 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Refer all servicing to qualified personnel.

The following caution label appears on your unit. Location: inside of the unit

CLASS 1LASER PRODUCT

D3-4-2-1-8*_C_En

  #  ! #  % ! # !     #"  " ! %!# !!  !   ! ##!  !     # %!! !    "& #! !! !  #  !! $#

" 

 

D3-4-2-2-2a_A_En

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it

Operating Environment

This product complies with the Low Voltage Directive

Operating environment temperature and humidity:

2006/95/EC and EMC Directive 2004/108/EC.

+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH

D3-4-2-1-9a_A1_En

(cooling vents not blocked)

 

 

Do not install this unit in a poorly ventilated area, or in

 

locations exposed to high humidity or direct sunlight (or

 

      

strong artificial light)

      

 

 

D3-4-2-1-7c*_A1_En

 

 

 

  

 

 

 

 

 

 

 

 

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

K058b_A1_En

damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement.

If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. If connected to an AC outlet, the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal.

The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when on vacation).

D3-4-2-2-1a_A1_En

2

En