ADVANCED OPERATIONS SECTION

To delete a cue point or loop information from memory

1Press the CUE/LOOP CALL button.

When the CUE/LOOP CALL button is pressed, the cue point or loop information is called up, and the unit enters the standby mode at the cue or loop-in point.

2At the cue or loop point you wish to delete, hold the CUE/ LOOP MEMORY button depressed for one second or more. The [MEMO] indicator will go out and the designated cue point or loop point information will be deleted.

•The information can be deleted from the BROWSE screen as well (P. 28).

SCRATCH PLAY

When the jog mode is set to [SCRATCH], pressing and rotating the top surface of the jog dial will cause playback to be performed in proportion to the direction and speed of jog dial rotation.

1Press the SCRATCH button.

The SCRATCH indicator will flash blue.

2During playback, press the surface of the jog dial. Playback will stop.

3Rotate the jog dial in the direction and at the speed you wish for playback to occur.

Playback will begin in the direction and at the speed corresponding to the jog dial input.

4Release hand from surface of jog dial. Playback will return to its original speed.

EFFECT SCREEN

When the EFFECT button is pressed, the center display will show the EFFECT screen, providing graphic expression to assist with scratch play and jog break play.

EFFECT

English

SPIN PLAY

During playback with the jog mode set to [SCRATCH], either press the surface of the jog dial or the play/pause () button to set the pause mode, then rotate the jog dial quickly; playback will proceed in response to the direction and speed of jog dial rotation, even if you remove your hand from the dial.

JOG BREAK PLAY

When the jog mode is set to [JOG BREAK], the pressing and

rotating the surface of the jog dial causes effects to be applied to the sound in proportion to the direction of rotation and rotation speed.

1Press the JOG BREAK button.

The JOG BREAK indicator will flash red.

2During playback, touch and press the surface of the jog dial.

3Rotate the jog dial.

4Release hand from surface of jog dial.

The effect will stop and sound will return to its original condition.

•Jog break play is not enabled when DJS or other DJ software tracks are loaded.

Function buttons[1] Scratch effect

When the jog mode is set to [SCRATCH], the screen on the controller side switches to scratch effect mode.

A blue ball will rotate in response to the track playback.

•The ball normally rotates to the right. When playback direction changes, the ball reverses direction, and when playback stops, the ball’s rotation also stops.

1During playback, press one of the function buttons [SCRATCH/TRANS/BUBBLE].

39

En