Pioneer PDP 5040HD Watching conventional TV channels, Selecting the antenna, Changing channels

08Basic Operations

Plasma Display (right view)

CHANNEL +/–

Channel display

PENDING

30

En

Watching conventional TV channels

Unless you set up conventional TV channels that you can watch under the current conditions, you cannot tune in those channels. For the procedure, see “Setting up conventional TV channels” on page 41.

•Conventional TV channels in this manual designate TV channels that are received through the conven- tional VHF/UHF frequencies or conventional cable TV channels.

Selecting the antenna

After confirming that the Mode switch on the remote control unit has been set to “TV”, press ANT on the remote control unit to select antenna A or B.

•Make this selection depending on the connections to the antenna input terminals on the Media Receiver (pages 24 to 26).

Changing channels

Using CH +/– on the remote control unit

•Press CH + to increase the channel number.

•Press CH – to decrease the channel number.

•CHANNEL +/– on the Plasma Display operates the same as CH +/–.

Using CH RETURN on the remote control unit

Press CH RETURN to switch the currently tuned channel to the previously tuned channel.

Press CH RETURN again to switch back to the currently tuned channel.

Using 0 – 9 on the remote control unit

Select channels directly by pressing buttons 0 to 9.

EXAMPLE

•To select channel 5 (1-digit channel), press 5.

•To select channel 25 (2-digit channel), press 2, followed by 5.

•To select channel 125 (3-digit channel), press 1, then 2, followed by 5.

•After entering a channel number, you may press CH ENTER to tune in the channel more quickly.

PDP5040HD-Eng (28-37) 30 7/24/03, 1:58 PM