Pioneer PDP 5040HD, PDP 4340HD manual Operating the control panel screen, Editing the i.LINK list

11Enjoying through External Equipment

Operating the control panel screen

The control panel screen appears when you press i.LINK. It disappears when you press i.LINK again. To select a button on the control panel screen, press / or /, and then press ENTER on the remote control.

1 2 3			@ # $ %
		PENDING
		Name
00:00:00	Status (Play)
Power			i.Link/DTV	~
			Device	!
Select ...	Enter [ENTER]		Close [i.Link]
4 5 6 7		8 9 0	- =

Editing the i.LINK list

The i.LINK list shows all devices connected through i.LINK interfaces. In this list, you can change the name or order of devices or delete device information.

To change the name of a device:

1Press / to select the desired device from the list, and then press ENTER.

2Press / to select “Rename”, and then press

ENTER.

1Shows the model and manufacture name of the D-VHS recorder to be operated.

2Shows counter time output by the D-VHS recorder.

3 Shows the current status of the D-VHS recorder. 4 Switches on and off the D-VHS recorder.

5 Starts recording.

6 Rewinds the tape.

7 Rewinds to the start of the current program.

8 Pauses the tape.

9 Starts playing back.

0	Stops the current tape motion.	3 Press / to change the character for the first
-	Forwards the tape.	digit.

=Forwards to the start of the next program.

~Switches the input source between i.LINK and DTV.

!Allows you to change the D-VHS recorder to be operated.

After pressing this button, press / to select the desired model from the list, and then press ENTER.

@Shows the type of inserted video tape; D for D-VHS, S for

S-VHS, and no display for VHS.

#Appears when any tape has been inserted.

$Appears when the inserted tape has been write protected. The inserted tape cannot be used for recording when this indicator appears.

%Appears when the D-VHS recorder has been preset for recording and is in the standby mode.

•If no i.LINK device has been connected, “No i.LINK devices are connected.” appears. If this is the case, connect i.LINK devices.

•If none of the connected equipment has been sup- ported for control, you cannot execute control.

•You can select A to Z, 0 to 9, special codes, and space in the order.

4Press / to move the cursor to the second digit.

5Press / to change the character for the second digit.

6Repeat steps 3 and 4 to enter up to eight digits, and then press ENTER.

7Press / to select OK, and then press ENTER.

74

En

PDP5040HD-Eng (65-80) 74 7/24/03, 2:00 PM