11Enjoying through External Equipment
To delete information about all devices:
1Press 
/
to select “Delete All”, and then press
ENTER.
2Press 
/
to select “Delete” and then press
ENTER.
Setting up for i.LINK standby
Use the following procedure to enable data transfer between multiple i.LINK devices even when the system is in the standby mode.
1Press HOME MENU.
2Press 
/
to select “DTV Setup”, and then press
ENTER.
•A confirmation message appears.
•A warning message appears if the selected device has been preset for recording with the timer or if its power is on. If you delete a device that has been preset for recording, its all presettings are deleted.
3Press 
/
to select “OK”, and then press ENTER.
3Press 
/
to select “i.LINK Setup”, and then press ENTER.
4Press 
/
to select “i.LINK Standby”, and then press ENTER.
5Press 
/
to select “Enable”, and then press
ENTER.
6Press HOME MENU to exit the menu.
•With “Enable” selected, the system relays data between multiple i.LINK devices even when in the standby mode; the i.LINK circuits are energized in that mode.
•With “Disable” (factory default) selected, less power is consumed when the system is in the standby mode; however the system does not relay data between multiple i.LINK devices. When i.LINK de- vices are not in connection, select “Disable”, result- ing in less power consumption.
In standby mode
i.LINK device | Media Receiver | i.LINK device |
| No data relay |
|
76
En
76 | 7/24/03, 2:00 PM |
