Preparation

05

Connecting the power cord

Connect the power cord last, after all other components are connected.

Plasma Display (rear view)

Power cord

English

AC IN terminal is located on the upper edge of the compartment.

Noise filter

Partially eliminates noise caused by the power source.

CAUTION

Use only the supplied power cord.

Use only the specified power supply voltage; neglecting this can result in fire or electric shock.

For the Plasma Display System, a three-core power cord with a ground terminal is used for safety reasons. Always connect the power cord to a three-pronged outlet and make sure that the cord is properly grounded.

NOTE

Always turn the panel’s power OFF when connecting or disconnecting power cords.

Disconnect the power cord from the wall outlet when the Plasma Display Panel is not going to be used for a long period of time.

Routing cables

When the speakers are installed on the sides Rear view

Speaker cable

Speed clamp

Attaching speed clamps to the main unit

Attach the speed clamps using the 3 holes (42 inches: 2 holes)

marked with an arrow () below, depending on your routing system. for PRO-1140HD

for PRO-940HD

Speed clamp

Speaker cable

Attaching and removing speed clamps

Insert [1] into an appropriate hole on the rear of the Plasma Display then snap [2] into the back of [1] to lock the clamp. Speed clamps are designed to be difficult to release once in place. Please attach them carefully.

Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed.

2

1

NOTE

Use the supplied speed clamps as necessary.

Bundle speaker cables so that none are pinched.

23

En

Page 23
Image 23
Pioneer PRO 1140HD, PRO 940HD manual Connecting the power cord, Routing cables