11Adjustments and Settings
No Operation off (AV mode only)
The system automatically enters Standby when no operation is performed for three hours.
1Press HOME MENU.
2Select “Power Control”. (
/
then ENTER)
3Select “No Operation off”. (
/
then ENTER)
4Select “Enable”. (
/
then ENTER)
Item | Description |
Disable | Does not place the system into Standby |
(factory default) |
|
|
|
Enable | Places the system into Standby if no operation is |
| performed for three hours |
|
|
Image position adjustment (AV mode only)
This function adjusts an image’s horizontal/vertical position on the Plasma Display.
1Press HOME MENU.
2Select “Option”. (
/
then ENTER)
3Select “Position”. (
/
then ENTER)
4Select “H/V Position Adjust”. (
/
then ENTER)
Position
H/V Position Adjust
Reset
5Press HOME MENU again to exit the menu.
NOTE
•Five minutes before the system is placed into Standby, a message appears as each minute counts down.
Power Management (PC mode only)
The system automatically enters Standby when no signal is received from the PC.
1Press HOME MENU.
2Select “Power Control”. (
/
then ENTER)
3Select “Power Management”. (
/
then ENTER)
4Select “Mode1” or “Mode2”. (
/
then ENTER)
Item | Description |
Off | No power management |
(factory default) |
|
|
|
Mode1 | • Places the system into Standby when no signal is |
| received from the PC for eight minutes |
| • Although the PC is accessed and a signal is |
| received again, the system stays off. |
| • Press STANDBY/ON on the Plasma Display or TV |
| on the remote control to turn the panel On |
|
|
Mode2 | • Places the system into Standby when no signal is |
| received for eight seconds |
| • Access the PC (a signal is received again), the |
| system turns On |
| • Press STANDBY/ON on the Plasma Display or TV |
| on the remote control to turn the panel On. |
|
|
5Press HOME MENU again to exit the menu.
62
5Adjust the vertical position (
/
) or horizontal position (
/
).
6Press HOME MENU again to exit the menu.
NOTE
•To restore the factory defaults, press 
/
to select “Reset” in step 4 then press ENTER. A confirmation screen appears. Press 
/
to select “Yes” then press ENTER.
•Adjustments are stored separately for each input source.
•Depending on the displayed video, the image position may not change even after adjustment.
Automatic image position and clock (Hertz) adjustments (PC mode only)
Use Auto Setup to automatically adjust image positions and clock speeds when coming from a PC.
1Press HOME MENU.
2Select “Option”. (
/
then ENTER)
3Select “Auto Setup”. (
/
then ENTER)
Option
Auto Setup
Manual Setup
• Auto Setup begins.
4Press HOME MENU again to exit the menu.
NOTE
•When Auto Setup is finished, “Auto Setup completed.” appears.
•Although “Auto Setup completed.” appears, Auto Setup may have failed, depending on conditions.
•Auto Setup may fail with a PC image composed of similar patterns or a monochrome picture. If Auto Setup fails, change the PC image and try again.
•The PC and the Plasma Display must be turned On before starting Auto Setup.
En
