Pioneer PRO 940HD Useful Remote Control Features, Learning function of the remote control unit

Press and hold TV afor more than two seconds.

• The remote control unit starts deleting all learned codes in the selected mode (marked by a lit LED).

• When completed, the LED blinks Off and the remote control unit returns to normal operation.

2

Press EDIT/LEARN and 2 at the same time.

• The LED indicator flashes and the remote control unit enters the Learning mode.

1

• Preset mode is finished when the LED blinks Off.

Library Search

In the event that the device code for a particular target unit is unknown, cycle through the available codes for that type of device. Sample the functions from each code in order to find the code that properly operates the target device.

1 Slide the Mode switch to match the type of device to be preset.

2 Press EDIT/LEARN and 3 at the same time.

• The LED indicator flashes and the remote control unit enters the Library Search programming mode.

3 Press either SOURCE POWER, PLAY, 1 or CH+ to sample the selected code.

4 If the code is missing, press / to advance to the next code or return to the previous code and repeat step 3.

5 Press ENTER when the code that properly operates the target device is found.

• All the available buttons for the selected mode are programmed to the remote control. The remote control unit returns to normal operation (LED lights for one second to confirm addition).

Delete Learning

You can delete a learned code by either overwriting it with a new code on the same button or performing the procedure below.

13Useful Remote Control Features

Learning function of the remote control unit

You can operate the connected AV products (AV Receiver, Cable Box, SAT tuner, VCR, DVD, DVD recorder, LD) using the remote control’s learning function. The remote control can memorize other remote control’s codes.

2 cm to 5 cm (0.8 inches to 2.0 inches)

Presetting manufacturer codes to control other devices

Presetting manufacturer codes

1Slide the Mode switch to match the type of device to be preset.

2Press EDIT/LEARN and 1 at the same time.

• The LED flashes.

3Press 0 – 9 to enter the manufacturer code. See page 92.

Remote control	Remote control of
(Supplied accessory)	AV product

Using the learning function

1Slide the Mode switch to match the type of device to be learned.

2Press EDIT/LEARN and 2 at the same time.

•The LED flashes.

3Press a button to be learned.

•The LED lights up.

•For the functions that can be learned, see pages 97 to 100.

•When the device’s remote is memorized, the LED flashes.

4Press EDIT/LEARN again to exit the Learn mode.

NOTE

•To exit the Learn mode before it is complete, press EDIT/ LEARN again.

•If the Mode switch selection is changed when EDIT/LEARN and 2 are pressed (the LED is flashing), the Learn session is canceled.

•If the Mode switch selection is changed when a button to be learned is pressed after EDIT/LEARN and 2 have been pressed (the LED lights up), the Learn session is not canceled and the selected mode and button remain effective.

•If no operation is performed for more than one minute after having pressed EDIT/LEARN and 2 (the LED is flashing), the Learn session is canceled.

•If a button to be learned is pressed after having pressed EDIT/LEARN and 2 (the LED is lit), the Learn session is canceled in 30 seconds and the LED restarts blinking again.

•Code transmission finishes in approximately two seconds. Do not interrupt it halfway. Wait until the LED flashes again.

•When using any of the receiver buttons (a, INPUT, or

VOL +/–), the learned manufacturer code remains the same regardless of the Mode switch position or even if the switch is shifted to a different position.

90

En