01Before you start

Before you start

(Symbol examples for batteries)

These symbols are only valid in the European Union.

!The demo mode is canceled automatically when the Full Auto MCACC operation is performed.

Checking what’s in the box

Please check that you’ve received the following supplied accessories:

!Setup microphone (cable: 5 m (16.4 ft.))

!Remote control unit

!AAA size IEC R03 dry cell batteries (to confirm system operation) x2

!AM loop antenna

!FM wire antenna

!iPod cable

!CD-ROM (AVNavigator)

!These operating instructions

Installing the receiver

!When installing this unit, make sure to put it on a level and stable surface.

!Don’t install it on the following places:

—on a color TV (the screen may distort)

—near a cassette deck (or close to a device that gives off a magnetic field). This may interfere with the sound.

—in direct sunlight

—in damp or wet areas

—in extremely hot or cold areas

—in places where there is vibration or other movement

—in places that are very dusty

—in places that have hot fumes or oils (such as a kitchen)

!Do not touch this receiver’s bottom panel while the power is on or just after it is turned off. The bottom panel becomes hot when the power is on (or right after it is turned off) and could cause burns.

Loading the batteries

The batteries included with the unit are to check initial operations; they may not last over a long period. We recommend using alkaline batteries that have a longer life.

WARNING

!Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It

can also reduce the life or performance of batteries.

CAUTION

Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions:

!Never use new and old batteries together.

!Insert the plus and minus sides of the batteries properly according to the marks in the battery case.

!Batteries with the same shape may have different voltages. Do not use different batteries together.

!When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

Pb

K058c_A1_En

Operating range of remote control unit

The remote control may not work properly if:

!There are obstacles between the remote control and the receiver’s remote sensor.

!Direct sunlight or fluorescent light is shining onto the remote sensor.

!The receiver is located near a device that is emitting infrared rays.

!The receiver is operated simultaneously with another infrared remote control unit.

30° 30°

7 m (23 ft.)

Canceling the demo display

On this receiver, the demo mode is turned on by default. When the power is turned on, the demo display is set and various indications are shown on the front panel display. To cancel the demo display, connect the power cord, then perform the operation below.

1Switch the receiver into standby.

2While holding down ENTER on the front panel, press uSTANDBY/ON. The display shows RESET cNO d.

3Select ‘FL DEMO’ using TUNE i/j.

4Use PRESET k/l to select FL DEMO cOFF dthen press ENTER on the front panel.

About operation of the receiver with a mobile terminal (iPod, iPhone, etc.)

The receiver can be controlled from the mobile terminal by installing a special application on the mobile terminal. For details, see the product information on the Pioneer website.

This special application may be changed or discontinued without notice.

About using AVNavigator (included CD-ROM)

The included AVNavigator CD-ROM contains Wiring Navi allowing you to easily make the receiver’s connections and initial settings in dialog fashion. High precision initial settings can be completed easily simply by following the instructions on the screen to make the connections and settings.

There are also other features enabling easy use of various functions, including an Interactive Manual that operates in association with the receiver, updating of various types of software, and MCACC Application that lets you check the MCACC measurement results on 3D graphs.

6En