Pioneer VSX-819H-K manual minute guide, 5Follow the instructions on-screen

025 minute guide

5Follow the instructions on-screen.

•Make sure the microphone is connected.

•Make sure the subwoofer is on and the volume is turned up.

•See below for notes regarding background noise and other possible interference.

6Wait for the test tones to finish.

A progress report is displayed on-screen while the receiver outputs test tones to determine the speakers present in your setup. Try to be as quiet as possible while it’s doing this.

1.Auto MCACC

Now Analyzing

Environment Check

Ambient Noise

Speaker YES/NO

Return

•For correct speaker settings, do not adjust the volume during the test tones.

7Confirm the speaker configuration. The configuration shown on-screen should reflect the actual speakers you have.

•With error messages (such as Too much ambient noise) select RETRY after checking for ambient noise (see Other problems when using the Auto MCACC Setup on page 11).

1.Auto MCACC

Check!

Front	[	YES ]
Center	[	YES ]
Surr	[	YES ]
Surr. Back	[YESx2]
Subwoofer	[	YES ]
10:Next			OK
			Return

If you see an error message (ERR) in the right side column, there may be a problem with the speaker connection. If selecting RETRY doesn’t fix the problem, turn off the power and check the speaker connections.

8Make sure ‘OK’ is selected, then press

ENTER.

If the screen in step 7 is left untouched for 10 seconds and the ENTER button is not pressed in step 8, the Auto MCACC setup will start automatically as shown below.

A progress report is displayed on-screen while the receiver outputs more test tones to determine the optimum receiver settings for channel level, speaker distance, and Acoustic Calibration EQ.

1.Auto MCACC

Now Analyzing

Surround Analyzing

Speaker System

Speaker Distance

Channel Level

Acoustic Cal EQ

Return

Again, try to be as quiet as possible while this is happening. It may take 1 to 3 minutes.

9The Auto MCACC Setup has finished! You return to the System Setup menu. The settings made in the Auto MCACC Setup should give you excellent surround sound from your system, but it is also possible to adjust

these settings manually using the System Setup menu (starting on page 41).1

If the speaker configuration displayed isn’t correct, use / to select the speaker and / to change the setting. When you’re finished, go to the next step.

Note

1• Depending on the characteristics of your room, sometimes identical speakers with cone sizes of around 12 cm (5 inches) will end up with different size settings. You can correct the setting manually using the Speaker Setting on page 42.

• The subwoofer distance setting may be farther than the actual distance from the listening position. This setting should be accurate (taking delay and room characteristics into account) and generally does not need to be changed.

10

En