12Additional information, Problem, Remedy

12Additional information

Problem	Remedy
Considerable noise in radio	• Connect the antenna (page 20) and adjust the position for best reception.
broadcasts.	• Route any loose cables away from the antenna terminals and wires.
	• Fully extend the FM wire antenna, position for best reception, and secure to a wall
	(or connect an outdoor FM antenna).
	• Connect an additional internal or external AM antenna (page 21).
	• Turn off equipment causing interference or move it away from the receiver (or
	move antennas farther away from equipment causing noise).

Broadcast stations cannot be	• Connect an outdoor antenna (refer to page 21).
selected automatically.

Noise during playback of a cassette deck.

• Move the cassette deck away from your receiver, until the noise disappears.

Sound is produced from other components, but not from LD or DVD player.

•Set the SIGNAL SEL to HDMI, C1/O1/O2 (DIGITAL) or A (analog) according to the type of connections made (refer to page 40).

•Set the digital input settings correctly (refer to page 44).

•Make digital connections (refer to page 14) and set the SIGNAL SEL to C1/O1/O2

(DIGITAL) (refer to page 40).

• Refer to the instruction manual supplied with the DVD player.

No sound is output or a noise is output when software with DTS is played back.

•Set the digital volume level of the player to full, or to the neutral position.

•Make sure the player’s settings are correct and/or the DTS signal out is on. Refer to the instruction manual supplied with the DVD player.

•Set the input signal type to C1/O1/O2 (DIGITAL) (see Choosing the input signal on page 40).

During a playback search, noise is output from a DTS compatible CD player.

•This is not a malfunction, but be sure to turn the volume down to prevent the output of loud noise from your speakers.

Everything seems to be set up	• Check that the positive/negative speaker terminals on the receiver are matched
correctly, but the playback	with the corresponding terminals on the speakers (see Connecting the speakers on
sound is odd.	page 22).

There seems to be a time lag	• See Automatically setting up for surround sound (MCACC) on page 9 to set up your
between the speakers and the	system again using MCACC (this will automatically compensate for a delay in the
output of the subwoofer.	subwoofer output).

After using the Auto MCACC	• Low-frequency noise could have been caused by an air conditioner or motor.
Setup, the speaker size setting	Switch off all appliances in the room and rerun the Auto MCACC Setup.
(LARGE or SMALL) is incorrect.

Can’t operate the remote	• Replace the batteries (refer to page 6).
control.	• Operate within 7 m (23 ft.), 30° of the remote sensor (refer to page 27).
	• Remove the obstacle or operate from another position.
	• Avoid exposing the remote sensor on the front panel to direct light.

The display is dark or off.	• Press DIMMER on the control repeatedly to return to the default.